CGA320 G1/2 CO2 Cylinder Refill Adapter w/ 36" Hose & Gauge Soda Maker Connector

Description

Product Description:
Specification: 36 Inch stainless steel braided Hose Dual Valve with Gauge, the hose's work pressure is 1500 PSI and the gauge is 3000 PSI, Thread for large CO2 tank is CGA320 and thread for soda stream tank is TR21-4.
Built-in Pressure Gauge: The product is equipped with pressure gauge, can clearly see the gas pressure range, the pressure control in a safe range.There are two on/off valves in our product, one is to control CO2 from the large cylinder into the small cylinder, and the other is to release the excess gas after filling.
Easy to Install and Please remember to use a spanner to tighten the connector to avoid leakage.
Attention: Please read the instructions before use; The big CO2 tank (donor cylinder) should have enough pressure, if it is liquid CO2, invert the big tank to inflate; If the small tank still cannot be inflated even follow the instructions to operate, we recommend replacing the thin thimble tank. ❌ Can not be used on paintball CO2 tank.
When the stainless steel braided Hose expands, check that the thimble of the vial is too thick to inflate. If so, replace the thin thimble bottle,then you can use it in normal. (Or contact us)
Inflatable Steps:
1. Place the gasket in the refill connector,confirm the On/Off and Release valve are closed, rotating the pin switch of small cylinder to the top.
2. Connect the fill station connector to the big bottle and connect the small cylinder to the soda stream Co2 adapter.
3. Close the release valve and open inlet valve.
4. Rotate the pin switch of the adapter clockwise to the bottom to allow gas to enter the small cylinder.
5. After fulling of gas by the small cylinder, contrarotate the pin switch to the highest position and close the inlet valve.
6. Open the release valve and exhaust the excess gas in the hose.
7. After inflating, unscrew the small cylinder.
Interface Size:
Thread for Large CO2 Tank: CGA320
Fits soda stream tank thread: TR21-4
Can't not be used on paintball CO2 tank.
Attention:
Please read the instructions before use.
Big CO2 tank (donor cylinder) should have enough pressure, if it is liquid CO2, invert the big tank to inflate.
If the small tank still cannot be inflated even follow the instructions to operate, we recommend replacing the thin thimble tank.
Packing included:
1x 36 Inch Stainless steel braided hose refill station with gauge